Structural-banner

DESCRIPTION

Structural Information
  • Note uniform design loads and any special loading.
  • Scaled and dimensioned foundation plans. Show ventilation and access openings as required.
  • Scaled and dimensioned floor and roof framing plans. Indicate all beam sizes, headers, ledgers, posts and columns. Note species and grade of lumber, or manufactured structural members performance grade.
  • Sections and details properly referenced to plans
  • Reinforcing steel, if used, for slabs, retaining walls, grade beams, foundations and foundation walls
  • For additions and renovations, detail the existing structure and footings that provide bearing for new work.
  • Structural calculations, signed and sealed by a structural design professional, licensed in the Commonwealth of Virginia, for those structural elements that exceed the tabular values set forth in the code, and for retaining walls with a difference in grade of greater than two feet.
  • General notes and construction notes
Mechanical Plans
  • New dwellings require:
    • heating/cooling load calculations
    • duct layout
    • complete mechanical layout and the equipment list (type and size) including exhaust system for kitchen, baths and dryer, venting systems and combustion make up air for fuel-burning appliances
    • prepared and signed by a licensed HVAC contractor, or architect or mechanical engineer with sealed drawings.
  • For alterations or additions to existing dwellings, the same requirements apply. However, the applicant has the option of attaching the Mechanical Plan Requirement Waiver form, signed by the property owner, to all sets of drawings. This allows the required information to bypass mechanical plan review and be reviewed at a later date by the field inspector at the time of the mechanical inspection.
  • When adding or replacing exterior units, a scaled, certified plat is required. It must clearly indicate the location of the new or replacement unit(s).
Plumbing
  • New houses will show the water service location and pipe size on the site/grading plan.
  • Renovations and additions to existing dwellings may continue to use the existing water service
  • Plumbing riser diagrams are not required, except for unusual features such as solar water heating systems.
  • All projects will show plumbing fixture layouts as part of the architectural plans.
Electrical
  • Compliance with the IRC for electrical is by field inspection only.
  • The Department of Environmental Services (DES) will need to review any boxes, devices, switches, towers, conduit, etc. that will be installed within the right of way. Plans shall show the riser diagram and a profile of purposed equipment.